Quick Listen is where I capture and share guitar tones that I’ve dialled in. No exploration; little discussion – just a quick audio demo or two along with a documented signal chain.

Today, I’ve made a quick recording of my ThorpyFX The Dane mk2 overdrive pedal into my Marshall DSL20HR. Click through to have a listen.
The Quick Listen
Here’s the ThorpyFX The Dane mk2, in overdrive mode, into the clean channel of my Marshall DSL20HR. I’m using my PRS McCarty 594.
The Signal Chain
Today, I’m using:
- Deadnote (my PRS McCarty 594)
- into the Axe-FX 3 (for the tuner)
- out to my pedalboard
- into the front of my Marshal DSL20HR
- speaker out to my Fryette Power Station PS-100
- line out back into the Axe-FX 3 (for virtual cab, delay and reverb)
- out to my audio interface
- and into my DAW.
All the delays and reverbs came from my Axe-FX 3. No post-processing was applied, but I do level-match all of my audio demos before uploading.
The Guitar
I’m using Deadnote – an all-stock PRS McCarty 594 from 2016. It features the original version of PRS’s 58/15LT pickups.
I’m playing in the middle pickup selector position (both humbuckers activated). The bridge pickup volume is at around 9, the neck pickup volume is at around 7, and both tone controls are slightly rolled down to taste.
The Pedal
I’m using ThorpyFX’s The Dane mk2 in its overdrive mode.
The settings are:
- Gain is around 10:30
- Tone is around 1 o’clock
- Level is around 11 o’clock
The other controls on the pedal only affect boost mode, which I’m not using today.
The Amp And Cab
I’m using my Marshall DSL20HR amp head on the Classic Gain channel.
The settings are:
- Volume at 12 noon
- Gain around 10 o’clock, to add some low-end warmth
- Treble around 1 o’clock
- Mids and Bass both around 11 o’clock
- Presence around 9 o’clock
- Resonance around 8 o’clock
- Reverb is off
The virtual cab uses official Celestion V-Type 1×12 open-backed cab impulse responses running in my Axe-FX 3. This is Scene 3 of my HTB Amp Head 2 Mic preset, built for my Marshall amp heads.
The Axe-FX 3 itself is running Firmware 33.02.
The Backstory
I’m partway through preparing my First Impressions post for ThorpyFX’s The J pedal. As part of that post, I wanted to hear two things:
- how The J sounds into the Marshall DSL20HR; the DSL20HR is (arguably) the affordable “pedal platform” amp in Marshall’s current line-up,
- and how The J takes drive and boost pedals.
I also needed to do some fine-tuning of my Celestion V-Type scene in my preset, as I wasn’t sure that it was quite right yet.
Seeing as everything was cabled up and on the board – and sounding so good – I thought I’d take a few minutes to record this sound for a Quick Listen.
Hopefully you’ll agree with me that The Dane mk2 sounds really good into this amp and speaker combo.
Final Thoughts
I had more fun with this signal chain than I was expecting to. Even I like a change from tweed-tone every now and then 😜
Now, I need to get back to recording the audio examples for my blog post about The J …
